 |
| Quantity: | |
|---|---|
DESCRIPTION：
BF-0385C PVC Use Fine Yangbuck Resin
PRODUCT NAME | BF-0385C |
APPEARANCE | Light yellow liquid |
MAIN COMPONENT | PU resin |
SOLID CONTENT(%) | 23±1 |
SOLVENT | MEK/TOL/MAC |
VISCOSITY(mPa·s/25℃) | 1500-2500 |
PROPERTIES & NOTES：
A.本品为表处型羊巴戈处理剂，经处理的皮革，仿真皮感强，价值感高
B.使用PUType有机色音或色料，色料应先溶解后加入，搅拌均匀
C.色料加入量度一般为3-7%，可根据具体要求调整
D.用于PU或PVC皮，一般以80目和100目各处理一次，上浆量约为70克，每次处理后，须先0.以120℃烘干，再以170℃-180℃*60秒发泡加热完成:完成的皮革，经表面处理后，效果更佳
E.本品久置会略有沉淀，使用前请先搅拌均匀，以免影响质量
F.安全保质期:二个月(30℃以下保存):
G.贮存条件:本剂严禁烟火，使用后请密封好，放于阴凉通风处，避免阳光直射或高温暴晒(否则会严重影响产品保质期及质量)。
A. The processed leather has a strong imitation leather feeling and a high sense of value.
B. Use PU Type organic color paste or color, color should be dissolved before adding, stirring well.
C. The usually amount of color is 3-7%, which can be adjusted according to specific requirements.
D. Using for PU or PVC leather.Generally using 80 mesh and 100 mesh are treated once each, and the sizing amount is about 70 g.120°C to dry each time→170-180°C X 60s to heat.
E. The finished leather can be treated with a surface treatment agent for better results.
F. Safe shelf life: 2 months(Over 2 months please test it before using).
G. Storage conditions: Strict fireworks, before and after use, please seal, put in a cool and ventilated place, avoid direct sunlight.
DESCRIPTION：
BF-0385C PVC Use Fine Yangbuck Resin
PRODUCT NAME | BF-0385C |
APPEARANCE | Light yellow liquid |
MAIN COMPONENT | PU resin |
SOLID CONTENT(%) | 23±1 |
SOLVENT | MEK/TOL/MAC |
VISCOSITY(mPa·s/25℃) | 1500-2500 |
PROPERTIES & NOTES：
A.本品为表处型羊巴戈处理剂，经处理的皮革，仿真皮感强，价值感高
B.使用PUType有机色音或色料，色料应先溶解后加入，搅拌均匀
C.色料加入量度一般为3-7%，可根据具体要求调整
D.用于PU或PVC皮，一般以80目和100目各处理一次，上浆量约为70克，每次处理后，须先0.以120℃烘干，再以170℃-180℃*60秒发泡加热完成:完成的皮革，经表面处理后，效果更佳
E.本品久置会略有沉淀，使用前请先搅拌均匀，以免影响质量
F.安全保质期:二个月(30℃以下保存):
G.贮存条件:本剂严禁烟火，使用后请密封好，放于阴凉通风处，避免阳光直射或高温暴晒(否则会严重影响产品保质期及质量)。
A. The processed leather has a strong imitation leather feeling and a high sense of value.
B. Use PU Type organic color paste or color, color should be dissolved before adding, stirring well.
C. The usually amount of color is 3-7%, which can be adjusted according to specific requirements.
D. Using for PU or PVC leather.Generally using 80 mesh and 100 mesh are treated once each, and the sizing amount is about 70 g.120°C to dry each time→170-180°C X 60s to heat.
E. The finished leather can be treated with a surface treatment agent for better results.
F. Safe shelf life: 2 months(Over 2 months please test it before using).
G. Storage conditions: Strict fireworks, before and after use, please seal, put in a cool and ventilated place, avoid direct sunlight.
